Hi I don’t know if this website keeps up-to-date or not but I got in my test enath and I had to get needles on my own so I got the needles which are insulin needles that are most commonly used by insulin meters and heroin people that read 1 mL /CC and has 100 units I understand that you have to take 500 mL a week which is two separate shots of 250 mg but I’m wondering if my needle that I have is the right type a needle to use for that so if I go to 10cc then it will equal 250 ml for one shot because my friend who also uses gear said to go to the 60 mL ???
If you are going to start your first cycle soon, 'how to inject' is probably that last thing that you are worried about. You would have started by conducting research on the different injectable anabolic steroids available in the market, whichyou think can help you reach your goal. But when you have the vials and the syringes in front of you, you will surely think about how you will get the steroid out from the bottle and into your body. At this point, some people will become exasperated and even give up. Here is some information on injecting anabolic steroids.
Next, carefully load a brand-new syringe by pulling back on the plunger as much as you can, inserting the syringe into the vial, and injecting the vial with air from the syringe. This creates negative pressure which will make it easier for you to fill your syringe. Next, place the tip of the needle in the solution and slowly pull back on the plunger, filling the syringe with about to more than you will need for your dose. Finally, hold the syringe upright with the needle facing the sky, and push up on the plunger gently to remove all the air. Stop when one or two drops of your solution escapes the needle.